Toast Rack Bike Racks This double-sided toastrack cycle rack enables the storage of 2 cycles per bike stand. The standard centres are 750mm; however, these can be increased to 800mm, 900mm or 1000mm to comply with BREEAM, if requested. The rack is fully welded with 4 pre-punched base plates for bolting to concrete. This model […]

Sheffield Cycle Stands Tubular Sheffield cycle stands can be supplied with base plates for bolting to concrete or with extended legs for setting into concrete. They are also available in stainless steel at an extra cost.  These cycle stands are the simplest yet most favoured by cyclists.  This classic design is the most convenient and […]

 Motorcycle locking rail   GENERAL SPECIFICATION Lengths: 1500mm, 3000mm or 3750mm Capacity: 4-5 motorcycles Overall width: 750mm Height: 300mm Length: 4000mm Diameter: 48.3 x 3.2mm Finish: Polyester Powder Coated to a standard BS or RAL Colou Fixing: Base plates for bolting to concrete or extended legs for submerging into concrete INSTALLATION These rails are fully […]

Scooter Racks Scooter Racks can be manufactured with pins to secure the scooter into position. These can then be locked with the users own padlock.  If required, they can be incorporated into a cycle shelter or waiting shelter.  An economy version of the scooter rack is available without the pin.  The single-sided scooter racks can […]

Scooter Stands Economy scooter stands are manufactured without pins. The scooter can be locked in position with the users own padlock.  The racks can be manufactured to any length.  If space is limited a wall mounted version can be manufactured. GENERAL SPECIFICATION OF SCOOTER RACKS Single Sided Lengths: 850mm, 1600mm Double Sided Lengths: 925mm, 1675mm […]

Bike Hooks This space saving bike hook cycle rack enables the storage of 4 cycles per bike rack. The standard bike hook centres are 360mm; however, these can be increased if required or adjusted to comply with BREEAM.  The rack is fully welded with 2 pre-punched base plates for bolting to the wall. Lengths: 1800mm […]

Wall Mounted Butterfly Design Cycle Stand Capacity:  1 No. Cycle per cycle stand Finish:  Hot dipped galvanised or Polyester Powder Coated Fixing:  Wall Mounted with 2 No. M12 x 100 sleeve anchors or resin anchor and stud bar Can be angled at 90 degrees for space saving solutions    

    Floor Mounted Butterfly Design Cycle Stands Capacity:  1 No. Cycle Fixing:  base plate for bolting to floor or extended for submerging into concrete Finish:  Hot dipped galvanised or Polyester Powder Coated Can be manufactured double sided for 2 bikes, if requested

  High Low Cycle Racks can be floor mounted or wall mounted All cycle racks are manufactured to order so can accommodate any number of cycles you wish to store. Bikes are stored on a one up one down basis to maximise the number of cycles which can be stored when space is limited. Cycles […]

  Front Wheel Support Butterfly Design Cycle Rack Can be floor mounted or wall mounted All cycle racks are manufactured to order so can be made to accommodate any number of cycles required. Manufactured at 600mm centres as standard